CDQ2B-X2839 系列 日本SMC偏心銷移位氣缸

CDQ2B-X2839 系列 日本SMC偏心銷移位氣缸

節省空間氣缸，薄形、裝置緊湊型設計
可在4面安裝小型磁性開關 ( Φ12到Φ25的是兩面)
磁性開關不突出表面
新追加雙耳環型、小型腳座型
：減少5%到13%(和以前的CQ2系列相比)
安裝螺絲同捆，設定了桿端安裝件的型號(省去了分別訂購氣缸和支件的時間)

CDQ2B-X2839 系列 日本SMC偏心銷移位氣缸
帶磁性開關 (CDQ2系列: CDQ2, CDQ2W, CDQ2K, CDQ2KW,CDQP2, CDQ2□S, CDBQ2)
When a work piece is mounted on the piston rod end, connect
them aligning the center of piston rod and a work piece. If they
are off-center, lateral load is generated and phenomena mentioned
in (1) may occur. In order not to apply the off-center load,
use of a floating joint or simple joint is recommended.
3. Simultaneous use of multiple cylinders
It is difficult to control the speed of pneumatic cylinders. The following
conditions cause speed change: change in supply pressure,
load, temperature and lubrication, performance difference
of each cylinder, deterioration of each part over time, etc. Aspeed
controller can be used to control the speed of multiple cylinders
simultaneously for a short period of time, but depending
on conditions, it may not work as desired. If multiple cylinders
cannot operate simultaneously, unreasonable force is applied
to the piston rod because cylinder positions may not be the
same. This may cause abnormal friction of seals and bearings,
and galling of cylinder tubes and pistons. Do not use an application
to operate several cylinders simultaneously by adjusting
cylinder speed. If this is inevitable, use a high rigid guide
against load, so that the cylinder is not damaged even when the
each cylinder output is slightly different.